If you are using this connector at its limits, I would encourage you to use 12AWG wire - for normal use cases 14AWG is plenty. Now you dont have to These connectors come with the wire leads. Replacing the XT60 with an EC5 is a good option if you want to add more current. Therefore they are often used in high C-rate lipo batteries. I tin the connector and the wire separately. Join the connector to be soldered with the mating end to make sure it does not distort during soldering. Great for rewiring your blaster to take a LiPo, making your flywheels easily. It still works, but it's not as confidence-inspiring as the other brand when I'm moving 50 amps for hours on end.įWIW, the PRC connectors are a darker yellow than the other-branded ones from Bezos Empire.īonus star, though, for including individually cut pieces of shrink tube. I guess that's to be expected between brands, but I'd think an XT60 would be an XT60. Doing this with cotton-thin stranded silicone 12 AWG wires is a real pain in the arse.įinally, once assembled, I find that they make a looser connection with the other branded Bezos Empire XT60 connectors (described as an internal pin / externally a female socket) than mating two of the same brand. That's pretty bad.įurther, the cups are so shallow as to be difficult to hold a wire in place while soldering - the ones I picked up from the Bezos Empire had relatively deep cups that held the wire in place before soldering. Of the pack I got, one of the cups broke off when I rotated it with my cutters (as is typical before soldering), which meant that the machining put the cup so close to the socket, it just snapped out with very thin walls between the two features. This Battery Extension Cable has a Male XT60 connector at one end and a Female XT60 connector at the other end, with 6 inches (150mm) of 12 AWG wire between. Personally, I wouldn't buy these again - I bought them expecting higher quality from PRC, but what I got was.
0 Comments
Leave a Reply. |